You are correct
You are correct. The information I had was from a site trying to sell me the newer design "IP" Torx bits, incorrectly identified as "metric".
Sometimes there is simply too much information available, making it difficult to separate the wheat from the chaff.
Complete thread:
- Stripped screw issue -
stonewalrus,
2017-11-22, 07:36
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Stripped screw issue - Robb Barnes, 2017-11-22, 08:53
- Stripped screw issue -
Fivegunner,
2017-11-22, 09:57
- Thanks we can try that - after a dose of penetrating oil - stonewalrus, 2017-11-22, 10:44
- To add a tiny bit to this... -
anachronism,
2017-11-22, 19:51
- Thats not actually correct... -
rob,
2017-11-24, 18:45
- You are correct -
anachronism,
2017-11-25, 10:09
- Sometimes I think... - rob, 2017-11-25, 12:37
- You are correct -
anachronism,
2017-11-25, 10:09
- Thats not actually correct... -
rob,
2017-11-24, 18:45
- Stripped screw issue - jgt, 2017-11-22, 11:41
- stripped screw. - bmize, 2017-11-22, 11:53
- Heat, solid vise, carbide center drill, drill press -
John K.,
2017-11-22, 22:12
- Heat, solid vise, carbide center drill, drill press - anachronism, 2017-11-23, 10:59
- If this is going on the rear sight rail... - rob, 2017-11-24, 19:00