To add a tiny bit to this...
To add a tiny bit to this, there are also metric Torx bits available. Between SAE & metric sizes, plus a little heat in case of a thread locker, you have an excellent chance for success.
Complete thread:
- Stripped screw issue -
stonewalrus,
2017-11-22, 07:36
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Stripped screw issue - Robb Barnes, 2017-11-22, 08:53
- Stripped screw issue -
Fivegunner,
2017-11-22, 09:57
- Thanks we can try that - after a dose of penetrating oil - stonewalrus, 2017-11-22, 10:44
- To add a tiny bit to this... -
anachronism,
2017-11-22, 19:51
- Thats not actually correct... -
rob,
2017-11-24, 18:45
- You are correct -
anachronism,
2017-11-25, 10:09
- Sometimes I think... - rob, 2017-11-25, 12:37
- You are correct -
anachronism,
2017-11-25, 10:09
- Thats not actually correct... -
rob,
2017-11-24, 18:45
- Stripped screw issue - jgt, 2017-11-22, 11:41
- stripped screw. - bmize, 2017-11-22, 11:53
- Heat, solid vise, carbide center drill, drill press -
John K.,
2017-11-22, 22:12
- Heat, solid vise, carbide center drill, drill press - anachronism, 2017-11-23, 10:59
- If this is going on the rear sight rail... - rob, 2017-11-24, 19:00