Heat, solid vise, carbide center drill, drill press
I know the left-hand drill bit part may seem difficult, but I've found them in most larger hardware stores. I just bought one from Ace Hardware to remove a broken sprue plate screw from a bargain mould I bought on ebay- $30.00 shipped, with one screw head broken off! I tried chasing the screw out with a sharp-faced punch, but it just didn't work out. The LH drill bit was a whopping $5.00 or so, and I should have bought one years and years ago.
Complete thread:
- Stripped screw issue -
stonewalrus,
2017-11-22, 07:36
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Stripped screw issue - Robb Barnes, 2017-11-22, 08:53
- Stripped screw issue -
Fivegunner,
2017-11-22, 09:57
- Thanks we can try that - after a dose of penetrating oil - stonewalrus, 2017-11-22, 10:44
- To add a tiny bit to this... -
anachronism,
2017-11-22, 19:51
- Thats not actually correct... -
rob,
2017-11-24, 18:45
- You are correct -
anachronism,
2017-11-25, 10:09
- Sometimes I think... - rob, 2017-11-25, 12:37
- You are correct -
anachronism,
2017-11-25, 10:09
- Thats not actually correct... -
rob,
2017-11-24, 18:45
- Stripped screw issue - jgt, 2017-11-22, 11:41
- stripped screw. - bmize, 2017-11-22, 11:53
- Heat, solid vise, carbide center drill, drill press -
John K.,
2017-11-22, 22:12
- Heat, solid vise, carbide center drill, drill press - anachronism, 2017-11-23, 10:59
- If this is going on the rear sight rail... - rob, 2017-11-24, 19:00