The 10/22 torment continues
Took the bolt in from the SBR to see about reducing its weight. Local SOT said no-too much wear on cutters, IHHO.
Which leads me to this. It is always without fail a saga for me to get the bolt back in. Must line up the retracting handle/bolt spring guide just right, and then slid ethe bolt back in on that. It requires a 3rd hand I forgot to have installed. So far I have a disassembled SBR, and a lot of frustration.
Is there a trick I don't know of?
The 10/22 torment continues
by Slow Hand 
, Indiana, Tuesday, July 09, 2024, 04:03 (136 days ago) @ A K Church
It’s honestly been awhile since I’ve had a 10/22 apart, but it seems to me that my issue was the bolt handle had to be pretty much perpendicular to the receiver to get it to fit in the fairly tight slot in the bolt. With the slop in the hole that the guide rod goes through, this is hard due to the leverage put on the handle out at the end. Seems like the bolt had to be all the way to the rear, which torques the handle back at a slight angle. I don’t know if you could grasp the charging handle with some soft jaw pliers and try to torque it back square, or pull it slightly too far to the rear, trying to catch the ‘far’ end of the handle in the slot, then let the handle forward a hair to get it to settle into the slot.