The Special One ...

It's the one that comes out on special occasions ... gets taken along for special occasions. The barrel is 20" .. being a singleshot the overall length is just really handy!

[image]

Previously I had mounted a shell holder on the forend for more reloads.

[image]

On one special occasion I grabbed the little gun and fired a heavy load of buckshot. The recoil ripped the shell holder off the forend! So I gave up on that idea.

Some of the special occasion loads:

500 gr. wadcutter
[image]

575 gr. round ball
[image]
Cast of wheelweight and pushed by 28 gr. of Unique it runs a bit over 1400 fps from the short barrel.

--
Ele era velho.
Ele era corajoso.
Ele era feio.

Post reply

1010 views

abbreviated fowling pieces in various gauges propped up in corners with a slug, two buckshot, and two birdshot on the butt. H & R, J.C Higgins, WesternField, etc.

Thought I had fetched a 16 ga. single J.C. Higgins from Kittery T.P. but when it got to the f.f.l., it was a five shot bolt action. Poor fellow who ordered the bolt listed for $45 more than the single was no doubt disappointed

[image]

Post reply

879 views

brasilian made ones as well. Spent a small fortune on rifled chamber adapters in various flavours from 3 inch to 2 feet in length only to determine that they really won't do anything at 40 paces that a high-brass #4 does better. But they are good to have I guess from survival scenario point of view.

[image]

egregiously blurry 18" 30-30 insert in 20 ga. rossi.

Post reply

907 views

NEF was still doing the barrel installation deal. Early oughts. They took for freaking ever, but they did good work pretty cheaply.

So I sent my new 12G WalMart NEF Pardner back to them for the installation of a 30" full choke barrel. Got it back, pulled the barrel, and proceeded to cut it (under gunsmith supervision) on a lathe back to 22"-the 30" barrel was pretty thick walled at the 22" mark, and that's why I chose it. Threaded it for Remington insert chokes, installed an unknown make poison green fluorescent front sight bar, and installed swivels and an M16 sling.

That was a GREAT setup. So of course I let it go. But if I lived in some place like Australia, where a gun "licence" is hard to get, and I wanted a gun of huge versatility, that might be it.

Post reply

852 views

I have an incredibly light j.c. higgins 12 gauge (stevens 94?) with a nearly 3 foot barrel that needs abbreviating but I am told it is a rarity once advertised as a "sears goose gun"

I vaguely remember, nigh-on two decades ago, chatting in the gloom of mister richardson's rock garden with a teddy savalas looking gentleman surnamed weiss or weinstein or weintraub and a given name of leonard or leroy or lester. The discussion was savage 24s and 20 and 12 gauge chamber inserts as a way of having an over/under double .22 hornet or 30-30.

Post reply

814 views

Not that long ago, there were half a dozen at least in my circle of friends and acquaintances. They were all working guns. Included one 20G 2 3/4" chamber Tenite number, still toiling away near 70 years after it was made.

Post reply

866 views

Is that the one I have? Honestly it doesn’t get shot much but not has ridden many a mile in the old F150! It’s set up still in the antenna bag with a big selection of birdshot, Buck and slugs. As well as a chamber adapter for .45 acp and a selection of those rounds and a dowel for ejection duties.

--
https://facebook.com/M2bKydex/

Post reply

843 views