Cool! I am thinking about doing that to my Dillons after you use them could you post how they work ???

Presses look good, report of the effectiveness of the upgrades in use.

I tried the shell plate bearing kit and the low mass ball. I pulled the ball out with a few hundred rounds. It was hard to index. The bearing was ok at first. I found it very susceptible to dirt, namely H110 powder. The little that slips out between the powder bar and powder dispenser body makes shell plate bind. I wish I could fix the H110 "drip".

..

I just did the primer slide upgrade with that kit and the ball bearing roller. Cured all the sticking problems I was having.

I also put one of those LED lights in the middle hole of the tool head. It really makes things easier to see now. Wish I had done this years ago.