Not as bad as I thought with some research
Yes, there is drilling involved but it is in the plastic/composite hand guard. There are nuts that fasten from underneath and the underside of the guide should have the hole placement marked.
Complete thread:
- Beretta Storm Carbine question -
stonewalrus,
2019-01-21, 17:40
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Beretta Storm Carbine question -
Catoosa,
2019-01-21, 19:17
- Red dot - laser would be easy. Side mount rail I have - stonewalrus, 2019-01-21, 19:39
- Not as bad as I thought with some research -
stonewalrus,
2019-01-21, 21:15
- Think you'll have it done by CSA? -
MS,
2019-01-22, 10:11
- Yes I intend to. This one is a 40 S&W. It was set up -
stonewalrus,
2019-01-22, 20:13
- Looking forward to it. - MS, 2019-01-23, 08:39
- Yes I intend to. This one is a 40 S&W. It was set up -
stonewalrus,
2019-01-22, 20:13
- Think you'll have it done by CSA? -
MS,
2019-01-22, 10:11
- So.. -
Byron,
2019-01-23, 21:34
- How did you get the Red Dot higher than the sights? - stonewalrus, 2019-01-24, 11:22
- So.. - Slow Hand, 2019-01-24, 12:29
- I have had great experiances SUB2000 in 40 S&W & 9mm - Rob Leahy, 2019-01-24, 13:57
- Beretta Storm Carbine question -
Catoosa,
2019-01-21, 19:17