Going to check with Ruger and see what they say.
If you do turn the barrel enough to center the rear notch, is it going put the front sight off center? I think that would bother me about as much as the rear being off center.
I've got an old S&W 1905 that came out of eastern Kentucky, allegedly owned by an old mountain gunfighter who had "customized" it to suit himself. One thing he did was to bend the front sight over quite a bit. Still has the plier marks on it. Looks really odd, but the old thing shoots dead on and so accurately that I have just left it alone. It's one of those guns that I REALLY wish could talk about where it's been and what it's done.
Complete thread:
- Ruger Single 10 report -
ERSisk,
2017-05-13, 23:30
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- I had an Accusport Bisley... - rob, 2017-05-14, 08:41
- Ruger Single 10 report -
Catoosa,
2017-05-15, 09:42
- Going to check with Ruger and see what they say. -
ERSisk,
2017-05-16, 22:20
- Going to check with Ruger and see what they say. -
Catoosa,
2017-05-17, 09:27
- Front is off center turning barrel will center both f & r -
ERSisk,
2017-05-17, 20:27
- Front is off center turning barrel will center both f & r - Catoosa, 2017-05-17, 22:45
- Front is off center turning barrel will center both f & r -
ERSisk,
2017-05-17, 20:27
- Going to check with Ruger and see what they say. -
Catoosa,
2017-05-17, 09:27
- Going to check with Ruger and see what they say. -
ERSisk,
2017-05-16, 22:20
- Ruger Single 10 report: What happened? - Mike P, 2018-03-21, 13:07