I was sorting brass last week...

by Slow Hand ⌂ @, Indiana, Saturday, April 15, 2017, 16:33 (2717 days ago)

And I came across two pieces of .454 Casull brass. I don't own a .454, so I thought well, I could trim them back to .45 Colt length, but then I remembered that they use small rifle primers so that sounded like too much trouble. So, today I picked this up to put those two pieces of brass to good use!


[image]


[image]


Luckily it came with two boxes of Hornady ammo, a set of RCBS dies and 200 pieces of Starline brass!! Now to load up some ammo and find time to get it to the range.

--
https://facebook.com/M2bKydex/

Post reply
  824 views

Watch the ERH, no recoil lug. Also, check the grips.

by John K., Saturday, April 15, 2017, 16:44 (2717 days ago) @ Slow Hand

If the locating pin is mislocated and redrilled, the grips will shift and crack.

Post reply
  807 views

There's a lot to be said...

by mcassill, Saturday, April 15, 2017, 17:46 (2717 days ago) @ John K.

for Freedom Arms quality in calibers like that.

Post reply
  795 views

I was sorting brass last week...

by Cherokee @, Medina, Ohio, Saturday, April 15, 2017, 18:18 (2717 days ago) @ Slow Hand

Hay, ya had the brass, you needed the gun. Good show, get out there and enjoy the new Ruger.

Post reply
  780 views

Nice! As mentioned, grips may require attention

by BC, IA, Sunday, April 16, 2017, 16:36 (2716 days ago) @ Slow Hand

At a minimum, make sure they are located correctly, that the wood fit to metal isn't too proud, and that they are tightened down enough.

Post reply
  716 views

RSS Feed of thread

powered by my little forum