CMC Powermags and Classics- skirted?

by Gunner , St Louis, Wednesday, August 03, 2016, 21:20 (3040 days ago) @ Sarge

CMC web site shows the classic devel style two finger follower in the mag, same with the classic.

In their FAQ section I found this......

When “bench testing” the fit of your CMC magazine, before inserting it into the pistol, first press down on the top forward section of the follower before inserting it into the pistol. This will place the follower in the same position it would be after the last round was fired out of the magazine. Again, with an empty pistol, keeping your finger off and out of the trigger guard, insert the magazine into the pistol. If you slowly insert the magazine it should easily go into the magazine well until the top of the magazine makes contact with the mag catch, at which point just briefly increase the upward force on the magazine to cam the mag catch open. Then the magazine should continue upward until you hear and/or feel a click from the mag catch when the magazine is fully seated and locked in the pistol. If the follower was seated properly, when you press the magazine release button, the magazine should eject out of the pistol’s magazine well. If the magazine release button is pressed and the empty magazine only extends out of the bottom of the pistol a little ways, you should be able to strip it out of the pistol. Simply slide the index finger of your support hand down the front strap of the pistol, making contact with the forward section of the base pad. Reseating the follower as described above should cure the problem of the magazine ejecting fully from the pistol.

Gunner

--
https://www.instagram.com/41gunner/
41 Mags rule, Baers rock!