I don't make my own bullets but wondered if there is an active bullet casting resource on this board? I'm looking for hard cast, gas-checked .38s and .45s. I'm looking for a couple thousand each to start...a mere pittance! I can always go to the commercial sources but wanted to check here first. If there is a good source from here, I would prefer to spend the $ with them. Thanks.

For commnon bullets like. 45 cal 200 grain SWC 9mm etc.. I use Missouri Bullet Co. They shoot as almost as good as mine. They're available with Hitech coating which is really good stuff.

I cast the non-common bullets or ones that I want a non-standard diameter like .431 for 44 mag and special or 45-70 bullets that are really expensive to buy....

I've bought from them before although I have not used the coating. You are picky so that's good to know.

You can buy .431 44mags from Penn Bullets as their standard diameter and save yourself that special effort.

It's good to see you back on the forum, Bryan!

I don't think any of our guys are currently involved in commercial production of projectiles. Creeker decided to start shooting all his, as did Tony and Aaron. Last year I was reduced to buying from internet sources prior to heading north, and then didn't get time to load any. Oh well, they'll be in the cache next time we head up there. I did shoot some I got from Tony years ago and had loaded, but inquiries here usually point to Missouri Bullets or other commercial casters rather than one of our own.

figured that was the case. I will go commercial.

I can recommend Penn Bullets, when I buy, I buy form them.

No matter where you get them, quality, commercially cast gas checked bullets will be pretty pricey. I like Montana Bullet Works because, in addition to a large selection of weights, and profiles, they also offer a range of diameters.

http://montanabulletworks.com/

Paul

For commercial cast, Magnus Bullets make several good options. Terry and Betty are very good folks to boot.