A boring 30'06 question

I am going to need to buy some brass for the used Vanguard I picked up last week So I am wondering if any of you fine folks have a preference for one brand over another? I also bought a factory refurbished Zeiss Conquest from Midway, that was a mistake, the only thing factory refurbished was the box. The glass looks like crap.

Dave

Post reply

587 views

Winchester would be my 2nd choice, if you can get it.

Post reply

510 views

I may be able to get my hands on some Winchester.

Post reply

515 views

If your feeling particularly rich, watch PowderValley for Lapua.
They've been out of stock for a while. The longest lasting I ever used was some Sako I got as an odd box on a country store shelf of 155 semi round loaded rounds back in the 1900's.

I have always normally run mine about midway between listed starting and max loads, with H4895 or IMR 4350 and get good life from it.

Post reply

487 views

You should be able to send the glass back. Fed and Win are good, but I also have had good service from RP if you can't get them.

Post reply

508 views

the Conquest series was built to compete for the US market and they downgraded the line to get the price point.

--
Of the Troops & For the Troops

Post reply

555 views

Overall the quality isn't quite on par with Leupold. One thing the Zeiss has that I really appreciate, is the eye relief is exactly the same at 9X as it is at 3X, first scope I have bought that did this. I am going to return it, and see about a 3-9x40 VX II.

Dave

Post reply

517 views

Works fine; you just have to remember the rangefinder shifts with the magnification. Reticle is too fine for normal hunting in AL - but it isn't really a hunting scope. Much prefer a Leupold M8-6x heavy duplex for that.

Way better than the cheaper Leupold versions; in comparable priced 'scopes, probably little difference.

Post reply

512 views

I just got a 5-20 and it's da bomb.

Post reply

459 views

Federal is good too. Winchester seems to have the most powder capacity. Remington is good brass, but usually quite a bit heavier than Winchester, so if you switch from Win or Federal to Remington, you may have to reduce your load a bit....

Post reply

519 views

I am loving this rifle! I like the price $275, I like the fit, and surprisingly enough for this magnum and 45/70 lover, I am loving going back to my 30-06 roots. With modern bullets, I wouldn't feel bad if it were all I had to hunt with.

Dave

Post reply

499 views

My most used brass is mil spec that was originally "clipped" for an M-1; this years deer load is in old, old Remington that pre-dates my current '06. I have a wide assortment, stuff from practically every company including Hansen and S&W!
bob

Post reply

500 views

I have a Heinz 57 stock of '06 brass that has been accumulating--and getting used up--for 15 years. I've also got an old 670 Winchester that don't seem to care... 3 shots of two different loads (Hornady plain base and boat-tail 150 grain bullets, H4895 all around) at 300 yards from mixed cases. Not match accuracy for sure but plenty good enough for anything I'm likely to do with it.

The Frontier Sixshooter Community Message Board

I like Federal, if you can get it.

Thank sir!

+1 on Fed or Win