What's the consensus on using 5.56 NATO brass
For reloading .223 ammo? I'm guessing it would require working up my loads again since capacity might be a bit less in the NATO brass.
Yep. I use it, no problems. I load my ammo so that
it can be used in the AR or in the Contender.
PS - I should note that I TRIM all my brass to the same length. IOW, I make it as alike as possible. Also, I've reformed a lot of it to 7mm TCU without problems.
--
Sincerely,
Hobie
What's the consensus on using 5.56 NATO brass
Used a bunch of it for bulk shooting in the 700 Remington. I simply treat it as any other brass.
What's the consensus on using 5.56 NATO brass
That is 99% of what I use, so I worked up my loads with 5.56. I have been told the capacity is the same, but safety would dictate care in switching from commercial to GI brass.
Very good then...I have a bunch of it and it looks like good
brass. I hate to let it go to waste.
How do remove the primer crimp.
I have an old Lyman hand cutter but I am thinking Dillon's little swage press maybe the way to go... Maybe save up and buy a RL1050 it has primer pocket swaging built in...
--
Of the Troops & For the Troops
Or buy brass that's already had that done
I have 3000 pieces of LC 5.56 brass sitting around that I will do something with someday
I used the RCBS primer pocket swager. Properly set up
it works fine and MUCH faster than using a deburring tool to cut away the crimp (I've done that, too).
--
Sincerely,
Hobie
if I don't give up on loading for the AR...
I'm gonna buy that RCBS swaging tool. But if I keep having fits with hand loaded ammo I'm gonna stop wasting my time and buy hunting ammo and XM193 for get off my lawn fodder. I'll use my reloading time for important stuff like .38 and .357, .44 Magnum, .30-06 and.45-70.