How's the action? Mine was SMOOOOTH!

--
Of the Troops & For the Troops

I picked up a nice Nickled 1917 a while back. The barrel needs to be turned a little but it shoots jacketed quite well. Cast not so much. I even tried some cast hard sized .454 that were loaded for my 25-2 ( another that does much better with jacketed) with mediocre to fair results.

You could try pushing a lead bullet down the bore. If it is very hard to push past then shooting it might be a problem.

would make a S&W Dobe Grant type gun

--
Of the Troops & For the Troops

Cool old gun! The finish looks to be pretty good despite the battered stocks. Looks like some nice case color remaining on the hammer and trigger. Too bad about the barrel.

I have a 1917 that shoots nicely with jacketed bullets and not bad at all with plated, but it just ain't impressed at all with cast bullets of any kind. I expect you will have to replace that barrel, but it will likely be worth the effort.

BTW, mine doesn't seem to care whether I use clips or not. I use cheap 1911 magazines as speedloaders. Cases usually fall right out, but filing a little bevel on the front lip of the floorplate makes a good extractor for those that don't.

The nineteen fifty-five barrel will not look good on the Brazilian. It has a rib on top that will not mate up with the slope on the front of the frame so there will be a noticeable gap that will look like k-rap eating a cracker. I would try lining the existing barrel or find an original barrel. Some of the re-bore guys may be able to clean your barrel up by cutting ever so slightly deeper grooves. You will like the results much better. Congratulations on your find. At least you have the gun for a project if it doesn't shoot with this barrel. Good luck.

Fire-lapping to see if you could dress off the bulge. Soft lead bullets at bore diameter impregnated with lapping compound fired at air gun velocity will knock the high spots off remarkably quickly.

These bulges are common under sight dovetails or when the barrel is over tightened and squeezes down at the throat and lapping will correct it in a few shots.

Fire-lapping may solve your problem without any muss or fuss.

Byron

which were imported along with the handguns some years back. These barrels popped up for some years, but seem to be scarce now. I had a new one, but Ed Harris swapped me out of it a year ago.

Anyway, there are some spare Brazilian barrels out there somewhere.

If you do wind up trimming that barrel just ahead of the ejector rod lug, here's an idea: Some years back there was a dealer at some of the shows around here who had a 1917 that had been cut like that. It had a barrel-band front ramp slotted on the bottom to clear the lug and sweated on the barrel, filed down and with a dovetail cut for a big gold bead. That was one of the slickest and MEANEST looking guns I've ever seen. I tried to buy it but he wanted way more than I was able to pay.