I know the ASM replicas are a bit lower quality than the Ubertis, but in picking one up at a good price. The seller says the half cock notch is broken, so I figured the easiest route would be to replace the hammer itself. Numrich's shows them but are out of stock, none to be found on eBay either. I may check with VTI but I was wondering if anyone knew of they were able to us an Uberti part. I'm sure I could get most anything to fit with enough work, but I'm trying to keep it somewhat simple!

Thanks,
Doug K

--
https://facebook.com/M2bKydex/

It seems to me, and my memory might be faulty on this, but the parts are NOT sufficiently similar. Call VTI and get the correct part.

--
Sincerely,

Hobie

years ago...they have given me fine service and both shoot to the same point of aim. I found the fit and finish to be fine whereas the Uberti 4.75" I have is not as nice. Get the correct part if you can.

Well, I boight it! Too good of a deal To pass up even though I didn't need it! I haven't taken it apart yet, but it seems to function just fine to me. If I get a chance To hit the range this weekend to test my new M&P 10, .308, I'll be sure
To bring it along with some good ammo to try out!

--
https://facebook.com/M2bKydex/

Quick pic...

I'm having thoughts of chopping to to 'store keepers' length and maybe trying to birds head the rear grip
Strap! Probably should just leave it alone though!!

--
https://facebook.com/M2bKydex/

What caliber is it?

.45 Colt. I haven't taken any measurements on cylinder throats just yet. Action is smooth, some wear to CCH, but a decent looking revolver overall. I doubt it will replace my Rodeo or .45 Flat Top, though!

--
https://facebook.com/M2bKydex/

can be seductive. I passed up one of those Uberti 4 3/4" .45 Colt Bisleys a couple uears ago 350$ on clearance new. Seemed to be a nice tight well done gun. Still have 'auto-kick-pants' reflex when it crosses my mind.