problem with the munchkin rifle

I made up a youth model rifle for my 6 yr old using a Remington 510. I had a new barrel installed and cut back. The problem is we are getting misfires even with CCI. Always fires by putting the shell back in and trying again wondering if it is weak spring, chamber space problem or what. Any ideas?

Post reply

435 views

barrel was replaced. Excessive headspace can easily cause this problem.

Post reply

397 views

Excessive dry firing can cause the firing pin to blunt out. Very common on Rugers. If the case has an excessively large hit Re square and flatten the face of the pin where it strikes the case. DONT SHORTEN. Just make it a bit narrower. J.Michael

Post reply

373 views

If it is headspace, what is the cure without getting complicated and expensive? I don't remember ever having a problem with the old barrel so I fear it is headspace (I drew a blank on the term and said chamber space).

Post reply

365 views

It could be something simple, like a spring or firing pin tip as JMichael mentioned. But it is highly suspicious that it appeared after a barrel replacement.

Can you post a pic of a fired case?

Was accuracy poor when shooting it? Sometimes indicative of excessive headspace as ignition is erratic.

Post reply

368 views

There a rectangular firing pin strike but it is a very shallow indentation.

Post reply

356 views

Tom, I just looked at some of those cases and the pin strikes are fairly well shaped, just very light. Even the ones that fired the first time have very shallow indentations. On the ones that had to be hit twice, the first mark is almost not there.

The case heads do not appear to be expanded as I would expect if there was too much headspace.

Post reply

326 views

Ensure there's no crud that would not allow the firing pin to travel fully forward.
put a bit of "pre-load" on the existing spring by placing a shim (washer of some sort) to enhance the power of the spring.
Install a new spring.

Post reply

342 views

Shim in the bolt. Sounded like a pretty simple fix. Apparently pretty common when changing barrels in them.

The Frontier Sixshooter Community Message Board

I would try a No-Go gauge first, particularly since the

Firing pin

I would try a No-Go gauge first, particularly since the

Just a suspicion at this point, as mentioned.

no luck on the picture with my camera

problem with the munchkin rifle

Which suggests some options...

Found an article on Remington 500 series about putting a

Time to get him his first AR.

I don't even have MY first AR