S&W 44 mag MountainGun barrel question
by Brien 
, NWArkansas, Tuesday, October 16, 2012, 11:07 (4423 days ago)
While looking at the barrel on a Mountain gun, i noticed that after the initial taper the barrel bulged and then tapered to the muzzle. The bore retained a consistent diameter throughout the length.
Has anyone else noticed this?
Thanks
Brien
can you post a picture?
by Rob Leahy 
, Prescott, Arizona, Wednesday, October 17, 2012, 09:45 (4422 days ago) @ Brien
I have 4 of em and can't quite fathom what it is other than the tapered outside contour.
--
Of the Troops & For the Troops
can you post a picture?
by Brien , NWArkansas, Wednesday, October 17, 2012, 10:11 (4422 days ago) @ Rob Leahy
The revolver is at a dealer. From the frame, the barrel tapers towards the muzzle. Most barrels have a straight taper. This one has a bulge about midway then tapers once again towards the muzzle. Looks like the usual stuck bullet bulge but the bore is straight, without any bulge. If you lay a straight edge along the barrel it is obvious. Very odd looking.
Bargaining point!
