What's your target weight Paul?

by Hoot , Diversityville, Liberal-sota, Thursday, July 26, 2012, 14:30 (4302 days ago) @ Paul

Also, do the lube grooves have a use on an air powered device? If not, it should be pretty straightforward to build an adjustable mold. Round nose milling cutter and a piece of 1/4" drill rod would get you a long ways down that road.....(this from a fella who hasn't cut a chip for over 35 years...)

Post reply

1694 views

Complete thread:

RSS Feed of thread

Anyone have a 257-420 mold laying around gathering rust? - Paul, 2012-07-26, 09:29
- Not quite.... - Hoot, 2012-07-26, 09:49
- Anyone have a 257-420 mold laying around gathering rust? - Wildcat, 2012-07-26, 10:36
  - Thanks, Hoot and Wildcat... - Paul, 2012-07-26, 11:18
    - That Lee mould was picked up on their surplus page. - Wildcat, 2012-07-26, 13:12
    - What's your target weight Paul? - Hoot, 2012-07-26, 14:30
      - Hoot, I'm not quite sure yet. Still reading, digging, - Paul, 2012-07-26, 14:53
        
        OK. The slugs I offered are for the .25ACP - Hoot, 2012-07-28, 08:16
        
        Somehow I had not caught that detail... - Paul, 2012-07-28, 11:53
      - OK. Some guys are getting great results with - Paul, 2012-07-30, 14:16
- I have a 257-312 I'm not really using - woody, 2012-07-26, 13:13
  - Thanks, Woody. - Paul, 2012-07-26, 14:55
    - Thought it would be but wanted to offer - woody, 2012-07-26, 20:39
- Why? - Byron, 2012-07-28, 11:08
  - Why? Well, geography, politics, personal inclination... - Paul, 2012-07-28, 11:50
    - Probably won't work anyway...... - Byron, 2012-07-28, 17:59
      - There is such a thing as an - Paul, 2012-07-28, 18:11
        
        Sounds like a lot of work... - Byron, 2012-07-29, 14:04
        
        Sounds like a lot of work... - Paul, 2012-07-29, 17:52

The Frontier Sixshooter Community Message Board

What's your target weight Paul?