The Frontier Sixshooter Community Message Board - I think if I had to I could get along pretty well with

I think if I had to I could get along pretty well with (reply)

stonewalrus — Thu, 16 Oct 2014 02:48:22 +0000

My Springfield XDS 45 and my Blackhawk with the acp cylinder.

My first Blackhawk... (reply)

Hoot — Wed, 15 Oct 2014 13:17:03 +0000

was a 7-1/2" convertible. The ACP's shoot as good as I can but I have never measured velocity.

As something of a stunt, I once used this Blackhawk in our Combat League. Most of the course of fire was pretty straightforward but it got interesting during the reload round where I had to swap cylinders....

I knew they were a pussycat to shoot. I figured acp was (reply)

Art — Wed, 15 Oct 2014 00:31:48 +0000

Have the 5.5 inch Ruger Bisley convertible. Only tried Winchester White box ACP and that was very accurate. Had the Colt cylinder reamed out to 452.5 for cast but did not bother with the ACP. It seems as tight as the Colt before reaming. Both cylinders are veray accurate with their respective loads. No idea about velocity.

I knew they were a pussycat to shoot. I figured acp was (reply)

stonewalrus — Sat, 11 Oct 2014 22:45:53 +0000

Cheaper to plink with and now with my 45 XDS I have good reason to keep plenty of 45 acp around.

thanks ! (reply)

cable — Sat, 11 Oct 2014 19:57:56 +0000

Everything depends on 'tolerances'. (reply)

Miles — Sat, 11 Oct 2014 19:24:51 +0000

This is from 12 years ago, or thereabouts

http://www.milesfortis.com/b&jguns/pistols/45.htm

The particular revolver is gone, but I still have the cylinder.
When I feel up to it, I may fit the cylinder to my other SAA

tell me about the cylinder you did for the colt? i have a (reply)

cable — Sat, 11 Oct 2014 19:06:24 +0000

third gen new frontier that i was pondering getting a 45 cap cylinder for

the cylinger-barrel gap acts like a ported barrel.... (reply)

Don Sikes — Sat, 11 Oct 2014 18:40:59 +0000

so think of an XD or a 1911 with a ported barrel compaired to a non ported barrel and you'll get a more accurate estimation of muzzle velocity... I used to carry my Ruger Sheriff's model (3.75" barrel) with an ACP cylinder around my ranch when I lived in Texas... at the time I had more ACP ammo than "long" Colts... so it was an obvious choice for me.

I have 2 B-Hawks like that (reply)

Miles — Sat, 11 Oct 2014 17:11:35 +0000

one made up like yours, one a factory convertible.

I even had a cylinder made up for a SAA Colt, which was an intriguing exercise in exasperation.

Everything seems to work OK in the Rugers. Accuracy, for you, should be no worse than with the larger case, and if the cylinder mouths are not cut small, you should see very good accuracy. It's like an extremely long freebore.

But now you've piqued my interest. I've not had the chrono out for a long time and I need to see what kind of fpses I get. Closest I could compare might be with the XD tactical as it has the longest barrel.

45 acp cylinder in Blackhawk - anybody played with one?

stonewalrus — Sat, 11 Oct 2014 16:40:41 +0000

I am just curious what you can get out of it accuracy and velocity wise. I bought one and fitted it to my 7 1/2" Blackhawk. I have fired it for function and where it hits to the sights relative to 45 Colt but that is it.