The Frontier Sixshooter Community Message Board - Been a little while since I was in that game but..

Been a little while since I was in that game but.. (reply)

Hoot — Mon, 07 Apr 2014 18:08:52 +0000

they seemed to be trading hands for $100-150 or so. A note/call to Ruger to see if they would fit one and the cost may be something to persue.

What is a decent price to pay for a cylinder (reply)

stonewalrus — Mon, 07 Apr 2014 03:01:35 +0000

There is one on eBay but don't know how high it will go.

I used the same cylinder in four differnt BHs...finally gave (reply)

Rob Leahy — Sun, 06 Apr 2014 17:12:00 +0000

to a young man just starting out in the sixgun game...
Too long or just right are what you want.

Chances are better than 50/50 in my experience (reply)

cubrock — Sun, 06 Apr 2014 13:51:24 +0000

Get them to measure the overall length of the cylinder and compare that to yours. Too long is okay, usually, as you can shorten the cylinder bushing with a bit of filing. Ruger's barrel/cylinder gaps are usually generous enough to allow a longer cylinder to fit. Much too short and you get bad endshake.

I already have a lead on one, just wonder if it would work (reply)

stonewalrus — Sun, 06 Apr 2014 13:47:36 +0000

45 acp cylinder for Blackhawk (reply)

Lee J. — Sun, 06 Apr 2014 13:44:14 +0000

Have one with my Stainless New Mod, Bisley, had it 3 months and haven't even tried it yet, but NO I don't wan to sell it. But the 45 Colt works well, just needs trigger job.

45 acp cylinder for Blackhawk

stonewalrus — Sun, 06 Apr 2014 13:10:55 +0000

If I can come up with an acp cylinder, what are the odds it would be a drop in for my 45 Blackhawk?