The Frontier Sixshooter Community Message Board - Yep:)

Yep:) (reply)

rob — Wed, 05 Mar 2014 18:19:18 +0000

Well done...Ol' Dan, a flood of good memories, right there. (reply)

Rob Leahy — Wed, 05 Mar 2014 17:55:18 +0000

Hammer and grip safety done... (reply)

Cherokee — Wed, 05 Mar 2014 13:03:54 +0000

Looks good, I used the Wilson safety on some of my 1911's.

I did finish installing the mainspring pin... (reply)

rob — Wed, 05 Mar 2014 04:19:34 +0000

Just now...right after reviewing these photos:)

Hammer and grip safety done...

rob — Wed, 05 Mar 2014 04:05:33 +0000

I had to remove a little material off the grip safety so it would lift over the trigger bow but otherwise it was drop-in and very simple. The hammer dropped right in except for having to transfer the hammer strut. Trigger feels good. The factory thumb safety dragged a bit after the hammer install and I'm sure it has to do with the new hammer engaging the sear at a different angle or some-such. I had a thought and for grins tried a Wilson thumb safety Ol' Dan gave me years ago. Boom! Popped right in and engages perfectly and snicks on and off positively and slicker than snot on a doorknob. Very happy with it. Now to test fire it when I can get back to the range.