The Frontier Sixshooter Community Message Board - That is an RCBS 44-200-CM mould....

That is an RCBS 44-200-CM mould.... (reply)

Glen — Sun, 11 Aug 2013 03:07:02 +0000

...that I had modified by Erik Ohlen to drop HP bullets.

Cool where can I get that bullet mould?? (reply)

Fivegunner — Sun, 11 Aug 2013 01:57:31 +0000

that`s a nice looking bullet, who makes the mould???

That's a neat little bullet. I like my 696 but I don't (reply)

Hobie — Sun, 11 Aug 2013 00:17:34 +0000

shoot it nearly enough.

I've been in kind of a snubby mood today.... (reply)

RidinLou — Sun, 11 Aug 2013 00:14:18 +0000

What does that HP look like after hitting wet clay or water filled jug?

180 grain HP at 1035 fps ought to do what needs doing.

My 3" Taurus would love that bullet and of course the worthless Bulldog would likely fire or misfire as only it could. Bulldog is s safe queen just because it is not useul for any other purpose.

The Taurus 431 is a great pistola with the sweetest trigger and puts 200 grain cast where ya point them. I guess I need to try some heavier bullets out of that gun and see what it will do with 250 RNFPs and some 429421s.

I've been in kind of a snubby mood today.... (reply)

Cherokee — Sat, 10 Aug 2013 23:33:35 +0000

That will do the job...

I've been in kind of a snubby mood today....

Glen — Sat, 10 Aug 2013 21:05:17 +0000

..so I sat down and cast up a few 188 grain cast HP's for my 3" S&W 696 .44 Special. Sized .429" and loaded over 8.7 grains of Unique, these cast HPs generate 1035 fps at standard pressures, and will put 5 rounds into about 2" at 50 feet. Not bad for a snubby....