The Frontier Sixshooter Community Message Board - IMR 4227 and the .357 Mugwump

IMR 4227 and the .357 Mugwump (reply)

woody — Wed, 13 Mar 2013 17:21:32 +0000

I use 14.5 grains under a 173 grain cast bullet. Shoots very good out of my NM Blackhawk and n frames. That is on the max side I believe so work up to it. That load shoots better than the same bullet under 2400 or 296 etc.

Also JT has a few good loads under his Taffin loads using 4227.

http://handloads.com/loaddata/taffin.asp

Possibly (reply)

FOG — Wed, 13 Mar 2013 16:25:07 +0000

But if you mean his name, I kind of doubt it.

In the old days, Chic was a pretty common men's nickname (for lack of a better term), and Gaylord didn't have the implications it does now (at least not very widely).

I suppose there might have been a few snickers here and there, but I bet there weren't many to his face.

Chic Gaylod: Yeah YOU THINK that HE didn't have (reply)

Rob Leahy — Wed, 13 Mar 2013 16:03:15 +0000

some compensating to do

That's more like it (reply)

FOG — Wed, 13 Mar 2013 15:09:37 +0000

"In my shop, we often say that anything less than 200 grains is effeminate." - Chic Gaylord

No offense to the otherwise inclined, of course.

IMR 4227 and the .357 Mugwump (reply)

Glen — Wed, 13 Mar 2013 13:48:59 +0000

I like 12.5 grains of 4227 with 200 grain cast bullets in the .357 Magnum.

However (reply)

Bud — Wed, 13 Mar 2013 13:28:14 +0000

do not try to use reduced loads with this powder.

IMR 4227 and the .357 Mugwump (reply)

Bud — Wed, 13 Mar 2013 13:09:16 +0000

I & H 4227 works great in 357Max, 357Herrett, 41, 44, 45lc & 454 using heavy CB's.

IMR 4227 and the .357 Mugwump (reply)

RidinLou — Wed, 13 Mar 2013 03:51:33 +0000

Give it to Tom to bring to me and I will burn it in the 357 Max and 357 Herrett.

Well, I've shot two... (reply)

pokynojoe — Wed, 13 Mar 2013 03:25:16 +0000

Here's the skinny, straight out of Lyman 47th Handbook.

The only two I've had experience with are the following:

Hornady 125gr jacketed hollowpoint: I used 16.0 grains (start: 15.6, max: 19.5)1.590"OAL

Hornady 158grjacketed hollowpoint: I used 13.5grains (start: 12.2, max:
16.1)1.590"0AL

NOTE WELL: THESE ARE "RIFLE" LOADS AND WERE SHOT OUT OF A MARLIN LEVER GUN.

I've shot some lead slugs to, but these were the two best that showed the best accuracy, out of that rifle.

There's a bunch of loads in the Lyman 47th for .357 using IMR 4227. I use to shoot IMR 4227, but not that much anymore.

Joe

IMR 4227 and the .357 Mugwump

Catoosa — Wed, 13 Mar 2013 03:01:33 +0000

I have most of a pound of IMR 4227 (figure out how old THAT stuff is) that I bought for some forgotten project. Anybody got a pet .357 Magnum load using 4227 that they'd share?