The Frontier Sixshooter Community Message Board - I put a couple ton of meat on the table with

I put a couple ton of meat on the table with (reply)

Bud — Sun, 06 Jan 2013 00:18:00 +0000

Sierra 165 gr BTSP's. What I liked about these projectiles is you could eat right up to the hole and not have to cut away and toss bloodtainted meat. Use same bullet in 308Norma for same results on elk. '06 on muley's and antelope.

should have added that there 150 power points (reply)

Lloyd Smale — Sat, 05 Jan 2013 11:42:52 +0000

Im not a big fan of bullets heavier then 165 in a non mag .30 cal.

Best Value .30-06 SP bullet for reloading (reply)

Lloyd Smale — Sat, 05 Jan 2013 11:41:24 +0000

never was a big fan of ww powerpoints but got a box of 500 of them pretty cheap and have shot quite a few deer with them. they preform great and the funny thing is two of my .30s love them. One is my ar10 and the other is my sps rem. Both shoot that bullet well under an inch at a 100 yards for 5 shots. the o6 sps does closer to 1/2 inch!

Best Value .30-06 SP bullet for reloading (reply)

cubrock — Sat, 05 Jan 2013 04:43:56 +0000

A good friend who shoots a Remington 700 reports cloverleaf accuracy with Remington Core-Lokts. Drops his deer dead-right-there.

Best Value .30-06 SP bullet for reloading (reply)

Dave B — Sat, 05 Jan 2013 03:44:57 +0000

I have had good luck with Rem Corelokts, and I watch Midway for blemished bullet sales.

I would think any major brand 150-180 grain (reply)

bj — Sat, 05 Jan 2013 03:15:26 +0000

Being a cheap so-and-so for many years now.... (reply)

Hoot — Sat, 05 Jan 2013 02:36:02 +0000

I've shot a lot of Hornady and Speer bullets. They both work. Remington Core-Lokt work also. I do see core separation now and again with each.....but it's always from a dead critter so I can't say it's a bad thing.

If I were out to pick up something, I'd likely come home with the Hornady 165gr plain base Interlock for the '06. For irrational reasons, I prefer 165-180 for the '06 and 150 and under for the .308---for what it's worth.

Also had good success in Son No. 1's rifle using Rem 180gr RN---hogs and deer.

Well... since "cheap" seems to be the operative word, (reply)

John K. — Sat, 05 Jan 2013 01:23:08 +0000

and since I agree high dollar premium bullets aren't necessary to shoot a whitetial through the ribs with an '06 at reasonable ranges, just about any bullet will suffice.

I will also throw this out - you can't get any cheaper than cast. Something like a Lyman 311284 over a caseful of WC872 will give results.

"Cheap components" is the definition of oxymoron these days. Likely to be more a case of "what do you have in stock" and unfortunately that is likely to be the expensive stuff.

Remington 150 JSP has worked fine in my 1917 (reply)

Cherokee — Sat, 05 Jan 2013 01:11:35 +0000

I appreciate all the discussion and humor, fellas... (reply)

AaronB — Sat, 05 Jan 2013 01:05:28 +0000

...I really do.

I'd like it even more if the odd straight answer were thrown in, just every now and again.

As my younger son would say, "Just sayin'"...

-Aaron

Wife gave me this for my last BD to hang in my shop (reply)

John K. — Fri, 04 Jan 2013 23:15:26 +0000

So I suppose I shouldn't say anything.

After the second shot... (reply)

Paul — Fri, 04 Jan 2013 21:38:01 +0000

Inquiry yeilds more info than snap judgments do (reply)

Paul — Fri, 04 Jan 2013 21:37:39 +0000

It got shot enough that the less than proper bedding job of the unknown 50's-60's era 'smith started to cause problems. It needs rebedded, perhaps restocked. I didn't have time enough to mess with it more than a cursory wipe down last time north.

After the second shot... (reply)

cas — Fri, 04 Jan 2013 21:10:38 +0000

…it becomes a two hole group?

That does not make any sense to me.... (reply)

Byron — Fri, 04 Jan 2013 20:04:57 +0000

If you rifle will shoot "one hole groups at 100 yards" why would you want to change the bedding?

Byron

Haven't priced them in a while... (reply)

Paul — Fri, 04 Jan 2013 18:03:47 +0000

but I really like the Hornady 165 gr BTSP. It is capable of one hole accuracy at 100 yards out of my old P17. I loaded up a box (50 rounds) of them late last fall over a snort of 760, 4895 would do good too I suspect but my best load was found with 760 and I've never seen a reason to change it. Now to get the rifle rebedded so I can shoot them next time up north... I'd like to get it pillar bedded but haven't found any kits for the P17 and can't afford to pay some fancy gunsmith to do it. But I digress, as usual.

Best Value .30-06 SP bullet for reloading

AaronB — Fri, 04 Jan 2013 17:51:39 +0000

For those of you who put up the occasional box of .30-06 reloads for deer hunting... if you were to buy bulk bullets today for that purpose, which would you choose?

I was thinking of your basic 150-grain PSP spitzer, though a 165 isn't out of the question either. Not interested in Nosler Partitions, Barnes X or other premium bullets, as I find that a Winchester silver tip or equivalent seems to do a dandy job on these little NC whitetails.

The load will probably involve either IMR 4895 or (more likely) IMR 4350. Not really interested in breaking new ground here.

Who's got a good price on what I'm looking for?

-AaronB