The Frontier Sixshooter Community Message Board - shoot me an email

shoot me an email (reply)

Todd Corder — Sat, 29 Dec 2012 16:06:58 +0000

lalaland at adams dot net

NEI Mould FS (reply)

Todd Corder — Sat, 29 Dec 2012 16:03:14 +0000

Looks like the one Ross Seyfried used in his Seville for Cape Buffalo.

NEI Mould FS (reply)

woody — Sat, 29 Dec 2012 12:47:48 +0000

Wish it was .458. Would make a good bullet for the 45-70

NEI Mould FS

bpjon — Fri, 28 Dec 2012 18:03:29 +0000

A few months back I bought 2 NEI moulds at a gun show. The gent had three on the table all at the same price, and I mistakenly took one mould I wanted and on I didn't. I don't have any contact info for the guy, and he's not a regular at our shows, so I can't get ahold of him to swap, so it's on the block.

The mould is a double cavity aluminum NEI, SWC, marked 350 454, so I'm assuming it is a 350 grain, .454" bullet. I think Uncle Elmer would like this one, it has three nearly equal, WIDE driving bands, and a generous, flat bottomed grease groove. It is plain based.

$65 tyd in the lower 48.