Dillon upgrades......

by Gunner @, St Louis, Saturday, June 20, 2020, 21:23 (1377 days ago)

First upgrade project was on my SquareD, never liked the small completed ammo bin, rigged up a much bigger bin and support shelf underneath for the weight.

[image]


Second upgrade project was my 550B, she's over 20 years old and needed a little TLC.


[image]


First issue was the primer system, added a JW Systems bearing slide plate....

https://www.ebay.com/itm/Dillon-550B-C-Primer-Track-Plate-w-Bearing-Kit/231859203676


Then a shell plate bearing kit.....

https://www.ebay.com/itm/Ultimate-Shellplate-Bearing-Kit-for-Dillon-RL-550B-RL-550C-550...


Finally some new springs and primer seating cup from Dillon....

[image]


Both are now ready for action and should run for years to come.


Gunner

--
https://www.instagram.com/41gunner/
41 Mags rule, Baers rock!

Dillon upgrades......

by Fivegunner @, LOWELL Mi., Sunday, June 21, 2020, 06:47 (1377 days ago) @ Gunner

Cool! I am thinking about doing that to my Dillons after you use them could you post how they work ??? :-D

Dillon upgrades......

by Cherokee @, Medina, Ohio, Sunday, June 21, 2020, 07:58 (1377 days ago) @ Gunner

Presses look good, report of the effectiveness of the upgrades in use.

Dillon upgrades......

by Mark, Monday, June 22, 2020, 18:16 (1375 days ago) @ Gunner

I tried the shell plate bearing kit and the low mass ball. I pulled the ball out with a few hundred rounds. It was hard to index. The bearing was ok at first. I found it very susceptible to dirt, namely H110 powder. The little that slips out between the powder bar and powder dispenser body makes shell plate bind. I wish I could fix the H110 "drip".

Nice Upgrades...........nt

by Creeker @, Hardwoods, Friday, June 26, 2020, 21:05 (1371 days ago) @ Gunner

..

Dillon upgrades......

by Scott Tschirhart, Saturday, November 28, 2020, 13:21 (1217 days ago) @ Gunner

I just did the primer slide upgrade with that kit and the ball bearing roller. Cured all the sticking problems I was having.

I also put one of those LED lights in the middle hole of the tool head. It really makes things easier to see now. Wish I had done this years ago.

RSS Feed of thread

powered by my little forum