Don't know what it'd take to ream a 357...
by Paul 
, Thursday, June 21, 2012, 08:06 (4334 days ago) @ cubrock
I know the 'smiths could do it fine, even line bore it - but that's more $$$ than is in the kitty for the project. I'm hoping to find either an ACP cylinder or a 44 cheap enough that I could then hand ream it myself. I'm not sure yet, but it seems that a Manson reamer should feed into a 44 cylinder with little problem. One would have to hog out more on the 357 before proceeding with the 45 ACP reamer, I THINK.
Complete thread:
- Pawl is on its way, still need a 45 ACP cylinder, or -
Paul,
2012-06-21, 07:40
![[*]](themes/default/images/complete_thread.png "Open whole thread")
- Pawl is on its way, still need a 45 ACP cylinder, or -
cubrock,
2012-06-21, 07:48
- Don't know what it'd take to ream a 357... -
Paul,
2012-06-21, 08:06
- Don't know what it'd take to ream a 357... -
cubrock,
2012-06-21, 08:21
- Don't know what it'd take to ream a 357... -
mcassill,
2012-06-23, 03:50
- Thanks, Mark. I'd forgotten that tidbit. (nt) - Paul, 2012-06-23, 07:46
- Don't know what it'd take to ream a 357... -
mcassill,
2012-06-23, 03:50
- Don't know what it'd take to ream a 357... -
cubrock,
2012-06-21, 08:21
- Don't know what it'd take to ream a 357... -
Paul,
2012-06-21, 08:06
- Pawl is on its way, still need a 45 ACP cylinder, or -
cubrock,
2012-06-21, 07:48